RAD Data comm IPmux-11 - Manual (Page 63)

Installation and Operation Manual Chapter 4 Configuration
IPmux-11 Ver. 2.00 Configuring IPmux-11 for Management 4-5
To define read, write and trap communities:
1. From the Management menu, select Authentication/community.
The Authentication/Community menu appears (see Figure 4-4 ).
2. From the Authentication/Community menu, do the following:
Select Authentication failure trap to enable or disable sending this trap in
case of an unauthorized access attempt.
Select Trap to enter the name of a community to which
IPmux-11 will send traps (up to 10 alphanumeric characters, case-sensitive).
Select Read to enter the name of a community with read-only
authorization (up to 10 alphanumeric characters, case-sensitive).
Select Write to enter the name of a community with write authorization
(up to 10 alphanumeric characters, case-sensitive).
Configuration>System>Management>Authentication/community
1. Authentication Failure Trap (Disable)
2. Trap ... (SNMP_trap)
3. Read ... (public)
4. Write ... (private)
>
Please select item <1 to 4>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-4. Authentication/Community Menu
Defining Network Managers
Define or modify the network management stations to which the SNMP agent of
IPmux-11 will send traps. Up to 16 managers can be defined. In addition, you can
enable or disable manager stations to receive traps.
To define network managers:
1. From the Management Access menu (see
Figure 4-1 ), select Manager list.
The Manager List menu appears (see Figure 4-4 ).
2. From the Manager List menu, perform the following:
Select Manager IP address, and enter an IP address of the manager station.
Select Manager Location and define the port via which the current
network manager accesses IPmux-11 according to the options below. This
option is available only if the VLAN tagging mode of both user ports is set to
Double Tag (see
Configuring the Ethernet Bridge section below). Only one
network manager at a time is allowed to access IPmux-11 via user ports.