RAD Data comm IPmux-11 - Manual (Page 51)

Installation and Operation Manual Chapter 3 Operation
IPmux-11 Ver. 2.00 Default Settings 3-5
Table 3-2. Default Settings (Cont.)
Parameter Default Value
Trail mode Termination
Physical Layer (ETH)
Channel state Enable
Auto negotiation • Disable for fiber optic interface
• Enable for copper interface
Max capability advertised 100baseT full duplex
Default type 10baseT half duplex
Connection
Connection mode Static
Destination IP address 0.0.0.0
Next hop address 0.0.0.0
IP TOS 0
Connection status Enable
Destination bundle –
TDM bytes in frame 1
Payload format V2
OAM connectivity Disable
Jitter buffer 3
VLAN tagging Disable
PSN Type UDP/IP
Outbound label tagging Disable
Inbound label tagging Disable
Next Hop Type IP
Far End Type (The current device interface type)
Bridge
Aging time 304
VLAN ID –
Status Enable
Rate limit 0 - Disable