RAD Data comm IPmux-11 - Manual (Page 50)

Chapter 3 Operation Installation and Operation Manual
3-4 Default Settings IPmux-11 Ver. 2.00
Table 3-2. Default Settings (Cont.)
Parameter Default Value
Fall back clock source Port1
Master clock External
Fall back clock Internal
Physical Layer (TDM, E1)
Admin status Enable
Transmit clock source Adaptive
Loopback state Disable
Rx sensitivity Short haul
Line type Framed G.704
Idle code 7E
Send upon fail OOS code
OOS code FF
OOS signaling Space
Mark signaling code D
Space signaling code 1
External Clock interface Balance
Trail mode Termination
Physical Layer (TDM, T1)
Admin status Enable
Transmit clock source Adaptive
Line type ESF
Line code B8ZS
Line interface DSU
Line BildOut 0 dB
Line length 0–133
Restoration time TR-6211 (10 seconds)
Idle code 7E
Send upon fail OOS code
OOS code FF
Signaling mode None
OOS signaling Space
Mark signaling code D
Space signaling code 1