RAD Data comm IPmux-11 - Manual (Page 119)

Installation and Operation Manual Chapter 6 Troubleshooting and Diagnostics
IPmux-11 Ver. 2.00 Testing IPmux-11 6-21
Diagnostics>Ping
1. Destination IP address ... (0.0.0.0)
2. VLAN tagging (Enable)
3. VLAN ID[1 - 4095] ... (0)
4. VLAN priority[0 - 7] ... (0)
5. Number of frames to send[1 - 4] ... (1)
6. Ping send
>
Please select item <1 to 6>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 6-17. Ping Menu
Running a Trace Route
You can run a trace route to a remote IP host to check the IPmux-11 IP
connectivity.
To run a trace route to an IP host:
1. From the Diagnostics menu (
Figure 6-4 ), select Trace route.
The Trace route menu appears (see Figure 6-18 ).
2. From the Trace route menu, configure the following:
Destination IP Address (IP address of the host to which you intend to trace
the route): 0.0.0.0 to 255.255.255.255.
VLAN Tagging:
Enable (VLAN tagging is enabled)
Disable (VLAN tagging is disabled)
VLAN ID: 1–4095
VLAN Priority: 0–7
The VLAN ID and VLAN Priority configuration is available only if the VLAN tagging is
enabled.
3. Select Trace route send to start the trace route.
Note