Proxim ORiNOCO AP-700 - Manual (Page 89)

Performing Advanced Configuration AP-700 User Guide
Radius Profiles
89
– If the RADIUS server does not send a Session-Timeout, the AP will set the subscriber expiration time to 0, which means indefinite
access.
– The Termination Action attribute defines how the Session-Timeout attribute will be interpreted. If the Termination Action is DEFAULT,
then the session is terminated on expiration of the Session-Timeout time interval. If Termination Action is RADIUS-Request, then
re-authentication is done on expiration on the session.
– If the RADIUS server sends a Session-Timeout, the value specified by the Session-Timeout attribute will take precedence over the
configured Authorization Lifetime value.
• Termination-Action
–
Valid values are: Default (0), RADIUS-Request (1)
• Idle Timeout
–
The AP internally maintains the Idle-Timeout attribute obtained for each of the users during their authentication process, and uses
this time interval in place of accounting inactivity time for timing out clients.
• Calling Station Id
–
MAC address of the client getting authenticated.
• Called Station Id
–
The AP sends the MAC address of its own wireless interface with which the client getting authenticated is getting associated,
appended with the SSID. If VLAN is enabled, the SSID and corresponding VLAN ID get appended.
• Acct-Interim-Interval
–
Obtained during the Authentication process and used for determining the time interval for sending Accounting Update messages.
– This attribute value takes precedence over the value of the Accounting Update Interval.
Accounting Attributes
• Acct-Delay-Time
–
Indicates how many seconds the AP has been trying to send a particular packet related to a particular user. This time can be used at
the server to determine the approximate time of the event generating this accounting request.
• Acct-Session-Time
–
Acct-Session-Time is calculated the following way (for each transmitted/retransmitted Acct-Stop): Acct-Session-Time = time of last
sent packet - subscriber login time.
• Acct-Input-Octets
–
Number of octets (bytes) received by subscriber.
• Acct-Output-Octets
–
Number of octets (bytes) sent by subscriber.
• Acct-Input-Packets
–
Number of packets received by subscriber.
• Acct-Output-Packets
–
Number of packets sent by subscriber.
• Acct-Terminate Cause
–
Indicates how the session was terminated.
• Vendor Specific Attributes