Parameter - A fundamental network value that can be displayed and may be changeable. For example, the Access Point must have a unique IP Address and the Wireless interface must be assigned an SSID. Change parameters with the CLI set Command, and view them with the CLI show Command.
•
Table - Tables hold parameters for several related items. For example, you can add several potential managers to the SNMP Table. All items for a given Table can be displayed with a show
CLI Command.
•
TFTP - Refers to the TFTP Server, used for file transfers.
Navigation and Special Keys
This CLI supports the following navigation and special key functions to move the cursor along the prompt line.
CLI Error Messages
The following table describes the error messages associated with improper inputs or expected CLI behavior.
Command Line Interface (CLI) Variations
Administrators use the CLI to control Access Point operation and monitor network statistics. The AP supports two types of CLI: the Bootloader CLI and the normal CLI. The Bootloader CLI provides a limited command set, and is used when the current AP Image is bad or missing. The Bootloader CLI allows you to assign an IP Address and download a new image. Once the image is downloaded and running, the Access Point uses the normal CLI. This guide covers the normal CLI unless otherwise specified.
Bootloader CLI
The Bootloader CLI is a minimal subset of the normal CLI used to perform initial configuration of the AP. This interface is only accessible via the serial interface if the AP does not contain a software image or a download image command over TFTP has failed. The Bootloader CLI provides you with the ability to configure the initial setup parameters as well as download a software image to the device. The following functions are supported by the Bootloader CLI: •
configuration of initial device parameters using the set command
•
show command to view the device’s configuration parameters
•
help command to provide additional information on all commands supported by the Bootloader CLI
Key Combination
Operation
Delete or Backspace
Delete previous character
Ctrl-A
Move cursor to beginning of line
Ctrl-E
Move cursor to end of line
Ctrl-F
Move cursor forward one character
Ctrl-B
Move cursor back one character
Ctrl-D
Delete the character the cursor is on
Ctrl-U
Delete all text to left of cursor
Ctrl-P
Go to the previous line in the history buffer
Ctrl-N
Go to the next line in the history buffer
Tab
Complete the command line
?
List available commands
Error Message
Description
Syntax Error
Invalid syntax entered at the command prompt.
Invalid Command
A non-existent command has been entered at the command prompt.
Invalid Parameter Name
An invalid parameter name has been entered at the command prompt.
Invalid Parameter Value
An invalid parameter value has been entered at the command prompt.
Invalid Table Index
An invalid table index has been entered at the command prompt.
Invalid Table Parameter
An invalid table parameter has been entered at the command prompt.
Invalid Table Parameter Value
An invalid table parameter value has been entered at the command prompt.
Read Only Parameter
User is attempting to configure a read-only parameter.
Incorrect Password
An incorrect password has been entered in the CLI login prompt.
Download Unsuccessful
The download operation has failed due to incorrect TFTP server IP Address or file name.
Upload Unsuccessful
The upload operation has failed due to incorrect TFTP server IP Address or file name.
See also other documents in the category Proxim Hardware:
