Monitoring the ap-700, 5 monitoring the ap-700 – Proxim ORiNOCO AP-700 User Manual
Page 104
AP-700 User Guide
104
5
Monitoring the AP-700
•
Provides version information for the Access Point’s system components.
•
ICMP:
Displays statistics for Internet Control Message Protocol packets sent and received by the AP.
•
Displays the AP’s IP Address Resolution table.
•
Displays the list of nodes that the AP has learned are on the network.
•
IAPP:
Provides statistics for the Inter-Access Point Protocol messages sent and received by the AP.
•
Provides statistics for the configured RADIUS server(s).
•
Displays the Access Point’s interface statistics (Wireless and Ethernet).
•
Displays statistics for stations and Wireless Distribution System links.
To monitor the AP using the HTTP/HTTPS interface, you must first log in to a web browser. See
Logging into the HTTP Interface
for
instructions.
You may also monitor the AP using the command line interface. Refer to
Using the Command Line Interface (CLI)
To monitor the AP via HTTP/HTTPS:
1. Click the Monitor button located on the left-hand side of the screen. The main Monitor screen will be displayed.
Figure 5-1
Monitor Main Screen
2. Click the tab that corresponds to the statistics you want to review. For example, click Learn Table to see the list of nodes that the AP has
discovered on the network.
3. If applicable, click the Refresh
button to update the statistics.
Each Monitor tab is described in the remainder of this chapter.