Proxim ORiNOCO AP-700 - Manual (Page 112)

AP-700 User Guide
112
6
Performing Commands
• Introduction to File Transfer via TFTP or HTTP : Describes the available file transfer methods.
• Update AP via TFTP: Download files from a TFTP server to the AP.
• Update AP via HTTP: Download files to the AP from HTTP.
• Retrieve File: Upload configuration files from the AP to a TFTP server.
• Retrieve File via HTTP: Upload configuration files from the AP via HTTP.
• Reboot: Reboot the AP in the specified number of seconds.
• Reset: Reset all of the Access Point’s configuration settings to factory defaults.
• Help Link: Configure the location where the AP Help files can be found.
To perform commands using the HTTP/HTTPS interface, you must first log in to a web browser. See Logging into the HTTP Interface for
instructions.
You may also perform commands using the command line interface. Refer to
Using the Command Line Interface (CLI) for more information.
To perform commands via HTTP/HTTPS:
1. Click the Commands button located on the left-hand side of the screen.
Figure 6-1 Commands Main Screen
2. Click the tab that corresponds to the command you want to issue. For example, click Reboot to restart the unit.
Following a brief introduction to TFTP and HTTP file transfer, each Commands tab is described in the remainder of this chapter.