Proxim ORiNOCO AP-700 User Manual
Page 182
Using the Command Line Interface (CLI)
AP-700 User Guide
Parameter Tables
182
NOTE
A priority mapping needs to be specified for a QoS Policy. The priority mapping depends on the type of policy configured. For Layer 2
policy types (inbound or outbound) a mapping index from the 802.1p to 802.1D table should be specified. For Layer 3 policy types
(inbound or outbound) a mapping index from the IP DSCP to 802.1D table should be specified. The mapping index, in both cases,
depends on the number of mappings configured by the user. For SpectraLink policy type a mapping is not required.
Specifying the Mapping between 802.1p and 802.1D Priorities
The QoS 802.1p to 802.1D Mapping Table specifies the mapping between 802.1P and 802.1D priorities.
Specifying the Mapping between IP Precedence/DSCP Ranges and 802.1D Priorities
The QoS IP DSCP to 802.1D Mapping Table specifies the mapping between IP Precedence/DSCP Ranges and 802.1D priorities.
QoS Enhanced Distributed Channel Access (EDCA) Parameters
The following commands configure the client (STA) and AP Enhanced Distributed Channel Access (EDCA) parameters.
The EDCA parameter set provides information needed by the client stations for proper QoS operation during the wireless contention period.
These parameters are used by the QoS enabled AP to establish policy, to change policies when accepting new stations or new traffic, or to
adapt to changes in the offered load. The EDCA parameters assign priorities to traffic types where higher priority packets gain access to the
wireless medium more frequently than lower priority packets.
NOTE
We have defined default recommended values for EDCA parameters; we recommend not modifying EDCA parameters unless strictly
necessary.
Name
Type
Values
Access
CLI Parameter
QoS 802.1p to 802.1D
Mapping Table
Table
N/A
N/A
qos1pto1dtbl
Table Index (Primary
Index)
Integer
0 - 7
R
index
802.1D Priority
(Secondary Index)
Integer
0 - 7
R
1dpriority
802.1p Priority
Integer
0 - 7
RW
1ppriority
Table Row Status
Row Status
enable
disable
delete
RW
status
Name
Type
Values
Access
CLI Parameter
QoS IP DSCP to 802.1D
Mapping Table
Table
N/A
N/A
qosdscpto1dtbl
Table Index (Primary
Index)
Integer
0 - 7
R
index
802.1D Priority
Integer
0 - 7
R
1dpriority
IP DSCP Lower Limit
Integer
0 - 62
RW
dscplower
IP DSCP Upper Limit
Integer
1 - 63
RW
dscpupper
Table Row Status
Row Status
enable
disable
delete
RW
status
Name
Type
Values
Access
CLI Parameter
EDCA Table
Table
N/A
N/A
qosedcatbl
Table Index
Integer
1 - 4
R
index
CWmin
Integer
0 - 255
RW
cwmin
CWmax
Integer
0 - 65535
RW
cwmax
AIFSN
Integer
2 - 15
RW
aifsn
Tx OP Limit
Integer
0 - 65535
RW
txoplimit
MSDU Lifetime
Integer
0 - 500
RW
msdulifetime
AC Mandatory
Truth Value
true
false
RW
acmandatory
QAP EDCA Table
Table
N/A
N/A
qosqapedcatbl
Table Index
Integer
1 - 4
R
index
CWmin
Integer
0 - 255
RW
cwmin