Proxim ORiNOCO AP-700 - Manual (Page 149)

Using the Command Line Interface (CLI) AP-700 User Guide
Other Network Settings
149
[Device-Name]>show dns
Figure A-14 Results of “show dns” CLI command
Configure DHCP Relay
Perform the following command to enable or disable DHCP Relay Agent Status.
NOTE
You must have at least one entry in the DHCP Relay Server Table before you can set the DHCP Relay Status to Enable.
[Device-Name]>set dhcprelaystatus enable
Configure DHCP Relay Servers
Perform the following command to configure and enable a DHCP Relay Server. The AP allows the configuration of a maximum of 10 server
settings in the DHCP Relay Agents server table.
[Device-Name]>set dhcprlyindex 1 dhcprlyipaddr dhcprlycmt dhcprlystatus 1 (1 to
enable, 2 to disable, 3 to delete, 4 to create)
Maintain Client Connections using Link Integrity
[Device-Name]>show linkinttbl (this shows the current links)
[Device-Name]>set linkinttbl <1-5 (depending on what table row you wish to address)>
ipaddr
[Device-Name]>set linkintpollint
[Device-Name]>set linkintpollretx
the link down>
[Device-Name]>set linkintstatus enable
[Device-Name]>show linkinttbl (confirm new settings)
[Device-Name]>reboot 0
Change your Wireless Interface Settings
See Interfaces for information on the parameters listed below. The AP-700 uses index 3.
Operational Mode
[Device-Name]>set wif mode
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device-Name]>set wif autochannel
[Device-Name]>reboot 0
Enable/Disable Closed System
[Device-Name]>set wif closedsys
Mode Operational Mode
1 dot11b-only
2 dot11g-only
3 dot11bg