Proxim ORiNOCO AP-700 User Manual
Page 87
Performing Advanced Configuration
AP-700 User Guide
Radius Profiles
87
Figure 4-34 Add RADIUS Server Profile
•
Server Profile Name: the profile name. This is the name used to associated a VLAN to the profile. Refer to
. The Server Profile Name is also used in the Configure > Management > Services page to specify the RADIUS profile to be
used for RADIUS Based Management Access.
•
MAC Address Format Type: This parameter should correspond to the format in which the clients’ 12-digit MAC addresses are listed
within the RADIUS server. Available options are:
— Dash delimited: dash between each pair of digits: xx-yy-zz-aa-bb-cc
— Colon delimited: colon between each pair of digits: xx:yy:zz:aa:bb:cc
— Single dash delimited: dash between the sixth and seventh digits: xxyyzz-aabbcc
— No delimiters: No characters or spaces between pairs of hexidecimal digits: xxyyzzaabbcc
•
Accounting update interval: Enter the time interval (in minutes) for sending Accounting Update messages to the RADIUS server. A
value of 0 (default) means that the AP will not send Accounting Update messages.
•
Accounting inactivity timer: Enter the accounting inactivity timer. This parameter supports a value from 1-60 minutes. The default is
5 minutes.
•
Authorization lifetime: Enter the time, in seconds, each client session may be active before being automatically re-authenticated.
This parameter supports a value between 900 and 43200 seconds. The default is disabled.
•
Server Addressing Format: select IP Address or Name. If you want to identify RADIUS servers by name, you must configure the AP
as a DNS Client. See
for details.
•
Server Name/IP Address: Enter the server’s name or IP address.
•
Destination Port: Enter the port number which the AP and the server will use to communicate. By default, RADIUS servers
communicate on port 1812.
•
Server VLAN ID: Indicates the VLAN that uses this RADIUS server profile. If VLAN is disabled, the text “VLAN is disabled” will
appear.
•
Shared Secret and Confirm Shared Secret: Enter the password shared by the RADIUS server and the AP. The same password
must also be configured on the RADIUS server.
•
Response Time (seconds): Enter the maximum time, in seconds, that the AP should wait for the RADIUS server to respond to a
request. The range is 1-10 seconds; the default is 3 seconds.
•
Maximum Retransmissions (0-4): Enter the maximum number of times an authentication request may be transmitted. The range is
0 to 4, the default is 3.
•
Server Status: Select Enable from the drop-down box to enable the RADIUS Server Profile.