Other network settings – Proxim ORiNOCO AP-700 User Manual
Page 148
Using the Command Line Interface (CLI)
AP-700 User Guide
Other Network Settings
148
NOTE
The configuration filename and TFTP server IP address are configured only when the AP is configured for Static IP. If the AP is
configured for Dynamic IP these parameters are not used and obtained from DHCP.
The default filename is “config”. The default IP address is “169.254.128.133” for AP-700.
[Device-Name]>set autoconfigstatus
[Device-Name]>set autoconfigfilename
[Device-Name]>set autoconfigTFTPaddr
Other Network Settings
There are other configuration settings that you may want to set for the AP. Some of them are listed below.
•
Configure the AP as a DHCP Server
•
•
and
•
Maintain Client Connections using Link Integrity
•
Change your Wireless Interface Settings
•
Set Ethernet Speed and Transmission Mode
•
Set Interface Management Services
•
•
•
•
Set Hardware Configuration Reset Parameters
•
NOTE
Refer to
Performing Advanced Configuration
for more information on these settings.
Configure the AP as a DHCP Server
NOTE
You must have at least one entry in the DHCP Server IP Address Pool Table before you can set the DHCP Server Status to Enable.
[Device-Name]>set dhcpstatus disable
[Device-Name]>set dhcpippooltbl 0 startipaddr
endipaddr
[Device-Name]>set dhcpgw
[Device-Name]>reboot 0
CAUTION
!
Before enabling this feature, confirm that the IP address pools you have configured are valid addresses on the network and do not
overlap the addresses assigned by any other DHCP server on the network. Enabling this feature with incorrect address pools will
cause problems on your network.
Configure the DNS Client
[Device-Name]>set dnsstatus enable
[Device-Name]>set dnsprisvripaddr