Proxim ORiNOCO AP-700 - Manual (Page 23)

Getting Started AP-700 User Guide
Hardware Installation
23
Mounting the AP-700 to a Wall
1. Put the mounting plate up to the wall.
2. Screw through the mounting plate.
3. Place the AP up against the mounting plate. Orient the AP with the long access vertical, with the connectors facing to the left.
Installing Range Extender Antennas
The Dual Band REA is a dual band indoor antenna that works with both 2.4 GHz (802.11b/g) and 5 GHz (802.11a) radios. You can optionally
install one to two Dual Band Range Extender Antennas on the AP-700.
Figure 2-5 Dual Band Range Extender Antenna
Perform the following procedures to mount the Dual Band REA to a wall or ceiling and to install it on the AP-700:
Wall Mount Installation
Perform the following steps to wall mount the Dual Band REA:
1. Detach the Antenna Body from the Main Base.
2. Press the Base Top upward to release it from the Main Base.
3. Use a metal plate or a coin to push the tenon between the Antenna body and the Base Top to remove the Base Top.
4. Screw the Base Top to the wall.
5. Attach the Antenna Body to the Base Top.
Normal Ceiling Installation
Perform the following step to mount the Dual Band REA to a normal ceiling:
•
Screw the antenna directly to the ceiling through the hole on the Base; use the anchor if necessary.
Base Top Base Top
Main Base Main Base
Antenna Body
Metal Plate Metal Plate
Bottom Plate
Screw Cavity