Proxim ORiNOCO AP-700 - Manual (Page 162)

Using the Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
162
Interface Parameters
Wireless Interface Parameters
The wireless interface group parameter is wif. For Single-radio APs, the wireless interface uses table index 3.
Common Parameters to 802.11a/b/g
Note 1: For 802.11a APs in Europe’s middle frequency band (5.25-5.35 GHz), Auto Channel Select is a read-only parameter; it is always
enabled.
Note 2: Wireless Service Status cannot be shutdown on an interface where Rogue Scan is enabled.
Note 3: Distance Between APs allows the AP to perform better in high noise environments by increasing the recieve sensitivity and transmit
defer threshold, as follows:
Name Type Values Access CLI Parameter
Wireless Interfaces Group N/A R wif
Table Index Integer 3 R index
Network Name DisplayString 1 – 32 characters
My Wireless Network
(default) RW netname
Auto Channel Select (ACS) 1 Integer enable (default)
disable RW autochannel
DTIM Period Integer 1 – 255
1 = default RW dtimperiod
RTS/CTS Medium Reservation Integer 0 – 2347
Default is 2347 (off) RW medres
MAC Address PhyAddress 12 hex digits R macaddr
Closed System Integer enable
disable (default) RW closedsys
Wireless Service Status 2 Integer 1 = resume
2= shutdown RW wssstatus
Supported Frequency Channels Octet String Depends on Regulatory
Domain R suppchannels
Load Balancing Max Clients Integer 1 – 63 R/W lbmaxclients
Antenna Diversity Integer 1 (Antenna 1),
2 (Antenna 2),
5 (Auto) R/W atdiversity
Distance Between APs 3 Integer 1 (large) (default)
2 (medium)
3 (small),
4 (minicell)
5 (microcell) R/W distaps
Distance
Between APs
Receive Sensitivity
Threshold
Transmit Defer
Threshold
Value dBm Value dBm
Large 0 -96 33 -62
Medium 9 -86 33 -62
Small 17 -78 43 -52
Mini 25 -70 53 -42
Micro 33 -62 59 -36