Proxim ORiNOCO AP-700 - Manual (Page 181)

Using the Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
181
Other Parameters
IAPP Parameters
NOTE
These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their default value unless a
technical representative asks you to change them.
Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters
The Wireless Multimedia Enhancements commands enable and configure Wireless Multimedia Enhancement/Quality of Service parameters
per wireless interface. The following two commands are part of the Wireless Interface Properties table.
Enabling QoS
Configuring QoS Policies
The QoS group manages the QoS policies:
Name Type Values Access CLI Parameter
IAPP Group N/A R iapp
IAPP Status Integer enable (default)
disable RW iappstatus
Periodic Announce
Interval (seconds) Integer 80
120 (default)
160
200 RW iappannint
Announce Response
Time Integer 2 seconds R iappannresp
Handover Time-out Integer 410 ms
512 ms (default)
614 ms
717 ms
819 ms RW iapphandtout
Max. Handover
Retransmissions Integer 1 - 4 (default 4) RW iapphandretx
Send Announce
Request on Startup Integer enable (default)
disable RW iappannreqstart
Name Type Values Access CLI Parameter
QoS Status Object Status enable
disable (default) RW qosstatus
QoS Maximum Medium
Threshold Integer 50 - 90 RW qosmaximummediumthreshold
Name Type Values Access CLI Parameter
QoS Group Group N/A N/A qos
QoS Policy Table Table N/A N/A qospolicytbl
Table Primary Index Integer N/A R index
Table Secondary Index Integer N/A R secindex
Policy Name Display String 0 - 32 characters RW policyname
Policy Type Integer inlayer2,
inlayer3,
outlayer2,
outlayer3,
spectralink RW type
Priority Mapping Index Integer See Note. RW mapindex
Apply QoS Marking Object Status enable
disable RW markstatus
Table Row Status Row Status enable
disable
delete RW status