Proxim ORiNOCO AP-700 - Manual (Page 156)

Using the Command Line Interface (CLI) AP-700 User Guide
CLI Monitoring Parameters
156
Set Hardware Configuration Reset Parameters
The Hardware Configuration Reset commands allows you to enable or disable the hardware reset functionality and to change the password
to be used for configuration reset during boot up.
To disable hardware configuration reset, enter:
[Device-Name]>set hwconfigresetstatus disable
To enable hardware configuration reset, enter:
[Device-Name]>set hwconfigresetstatus enable
To define the Configuration Reset Password to be used for configuration reset during boot up, enter the following command
[Device-Name]>set configresetpasswd
It is important to safely store the
NOTE
It is important to safely store the configuration reset password. If a user forgets the configuration reset password, the user will be
unable to reset the AP to factory default configuration if the AP becomes inaccessible and the hardware configuration reset
functionality is disable.
Set VLAN/SSID Parameters
Enable VLAN Management
[Device-Name]>set vlanstatus enable
[Device-Name]>set vlanmgmtid <-1-4094>
[Device-Name]>show wifssidtbl (to review your settings)
[Device-Name]>reboot 0
Disable VLAN Management
[Device-Name]>set vlanstatus disable or 2
[Device-Name]>set vlanmgmtid 0
[Device-Name]>reboot 0
Add a Entry to the WIFSSID Table
[Device-Name]>set wifssidtbl ssid vlanid <-1-4094> status enable
CLI Monitoring Parameters
Using the show command with the following table parameters will display operating statistics for the AP (these are the same statistics that are
described in
Monitoring the AP-700 for the HTTP Web interface).
• staticmp: Displays the ICMP statistics.
• statarptbl: Displays the IP ARP Table statistics.
• statbridgetbl: Displays the Learn Table.
• statiapp: Displays the IAPP statistics.
• statradius: Displays the RADIUS Authentication statistics.
• statif: Displays information and statistics about the Ethernet and wireless interfaces.
• stat802.11: Displays additional statistics for the wireless interfaces.
• statethernet: Displays additional statistics for the Ethernet interface.
• statmss: Displays station statistics and Wireless Distribution System links.