Proxim ORiNOCO AP-700 - Manual (Page 21)

Getting Started AP-700 User Guide
Hardware Installation
21
Hardware Installation
Unpack the Access Point and accessories from the shipping box. Verify the contents as follows:
•
AP-700 unit
• Mounting bracket with screws
• Power adapter
• Security cover
• Quick Installation Flyer
• Software CD
Perform the following procedures to install the AP hardware:
•
Cabling the AP-700
• Installing the Security Cover
• Mounting the AP-700
• Installing Range Extender Antennas
Cabling the AP-700
Connect cables to the AP-700 as follows:
1. Plug the power cord into the power jack (the left port) and connect the unit to an AC power outlet (100~240V, 50~60Hz).
2. If using active Ethernet, connect power to the unit from a DC injector device, such as the ORiNOCO 1-Port Active Ethernet DC Injector
hub.
3. Attach one end of an Ethernet cable to the AP's WAN port (the center port, labeled “WAN”) and the other end to a network hub or switch.
4. Optionally, connect an RS-232 cable to the RS-232 console port (the right port, labeled “RS-232”).
NOTE
You cannot install the security cover to the AP-700 if an RS-232 cable is connected.
Figure 2-3 Cabling the AP-700
5. Verify LED Status
6. When the AP-700 boots, it performs a series of self-tests.
7. Wait for the power LED to turn green before proceeding.