Proxim ORiNOCO AP-700 - Manual (Page 168)

Using the Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
168
than the backslash character ("\") when configuring the Help Link location.) The AP Help information is available in English, French,
German, Italian, Spanish, and Japanese.
Telnet Parameters
Serial Port Parameters
RADIUS Based Management Access Parameters
The RADIUS Based Management Access parameters allow you to enable HTTP or Telnet Radius Management Access, enable or disable
local user access, and configure the local user password.
The default local user ID is root and the default local user password is public. “Root” cannot be configured as a valid user for RADIUS based
management access when local user access is enabled.
SSH Parameters
The following commands enable or disable SSH and set the SSH host key.
The AP SSH feature, open-SSH, confirms to the SSH protocol, and supports SSH version 2.
Name Type Values Access CLI Parameter
Telnet Group N/A R telnet
Telnet Management
Interface Bitmask Interface Bitmask 0 or 2 - no interfaces
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless
5 or 7 - all interfaces
(default is 7) RW telifbitmask
Telnet Port Integer User Defined
23 (default) RW telport
Telnet Login Inactivity
Time-out Integer 1 – 300 seconds
30 sec (default) RW tellogintout
Telnet Session Idle
Time-out Integer 1 - 900 seconds
900 sec (default) RW telsessiontout
Name Type Values Access CLI Parameter
Serial Group N/A R serial
Baud Rate Integer 2400, 4800,
9600 (default),
19200, 38400, 57600 RW serbaudrate
Data Bits Integer 8 R serdatabits
Parity Integer none R serparity
Stop Bits Integer 1 R serstopbits
Flow Control Value none (default)
xonxoff RW serflowctrl
Name Type Values Access CLI Parameter
Radius Local User Status Integer Enable
Disable RW radlocaluserstatus
Radius Local User Password DisplayString User Defined RW radlocaluserpasswd
HTTP Radius Management
Access Integer Enable
Disable RW httpradiusmgmtaccess
Telnet Radius Management
Access Integer Enable
Disable RW telradiusmgmtaccess
Name Type Values Access CLI Parameter
SSH Status Integer Enable
Disable RW sshstatus
SSH Public Host Key Fingerprint DisplayString AP Generated RW sshkeyfprint
SSH Host Key Status Integer Create
Delete RW sshkeystatus