Proxim ORiNOCO AP-700 - Manual (Page 44)

Performing Advanced Configuration AP-700 User Guide
Interfaces
44
Interfaces
From the Interfaces tab, you configure the Access Point’s power control settings, wireless interface settings and Ethernet settings. You can
configure the operational modeand the Transmit Power Control settings. You may also configure a Wireless Distribution System for AP-to-AP
communications. The Interfaces tab contains the following sub-tabs:
•
Operational Mode
– Super Mode and Turbo Mode
– Enable 802.11d: enables IEEE 802.11d support for additional regulatory domains. Refer to the IEEE 802.11d Support for Additional
Regulatory Domains and Configuring 802.11d Support sections.
– ISO/IEC 3166-1 CountryCode: the country (regulatory domain) where the AP is located.
– Enable TX Power Control: enables TX Power Control to control transmit power of 802.11-enabled clients within an IBSS. Refer to
the
TX Power Control and Configuring TX Power Control sections.
– Transmit Power Level: the power level of the interface when IBSS Power Control is enabled. Allowed values are 100%, 50%, 25%,
or 12.5%.
• Wireless (802.11a/b/g Radio)
• Ethernet