IBM INFOPRINT 6500 - Manual (Page 66)

Chapter 2 Configuration Tools
66
Equivalent Wireless Ethernet Interface
Configuration Using The Telnet Command
store ifc 2 wlan ssid
store ifc 2 wlan mode adhoc|pseudo|managed
store ifc 2 wlan speed auto|(1 2 5 11)
store ifc 2 wlan channel default|(1-15)
store ifc 2 wlan antenna diverse|primary|aux
store ifc 2 wlan preamble default|long|short
store ifc 2 wlan pmm on|off
store ifc 2 wlan txpwr (0-100)
store ifc 2 wlan opts [[-]openauth][[-]intnl]
store ifc 2 wlan defkey disable|(1-4)
store ifc 2 wlan key
store ifc 2 wlan auth (e.g. openauth, shared, leap,
kerb)
store ifc 2 wlan user
store ifc 2 wlan pass
Refer to page 328 for the complete command set.
Wireless Cisco LEAP
LEAP is a Cisco wireless security scheme. The Cisco LEAP allows
for a WEP key timeout that forces re-authentication, resulting in the
derivation of a new WEP key for the session. To enable LEAP in
the NIC, enter the username and password corresponding to the
RADIUS server with the following commands:
store ifc 2 wlan auth leap
store ifc 2 wlan user
store ifc 2 wlan pass
NOTE: Disable the defkey to use LEAP.