IBM INFOPRINT 6500 - Manual (Page 259)

Configuring PSF for IPDS On V4R2 And Above
259
Verifying The IPDS Configuration On iSeries
To test IPDS printing:
1. If it is not already on, vary on the line description:
VRYCFG CFGTYPE(*LIN)
2. To start TCP/IP, enter STRTCP.
3. Verify that the iSeries TCP/IP interface is active. Use the
command:
WRKTCPSTS
and then select option 1.
4. Turn the printer on and wait until the printer control panel
displays “ETHERNET IS READY.”
5. To verify the printer is connected to iSeries, ping the printer
from an iSeries workstation with one of the following
commands:
PING ip_address
or
PING hostname
where ip_address is the Internet address of the remote
system printer (the Ethernet Interface), and hostname is the
hostname you defined for the printer, if any.
• If the ping is not successful, refer to “Cannot PING The
Printer” on page 262.
• If the ping is successful, vary on the printer device
description with the command:
VRYCFG ( printer_device) CFGTYPE(*DEV)
STATUS(*ON)
6. To use PSF to send an IPDS file to the printer, enter:
STRPRTWTR DEV ( printer_device)
where printer_device is the name of the printer.
7. If you have problems printing, do the following:
• Print an Ethernet Test Page. Refer to your User's Manual.
• Verify that port number 5001 is being used.
Verifying The IPDS Configuration On iSeries