IBM INFOPRINT 6500 - Manual (Page 359)

List Commands
359
list model [model]
List the current model settings (e.g., names and mapped
destinations). List the current model settings (e.g., names and
mapped destinations). With no
model parameter, a table of
values for name, type, banner, config and the size in bytes of
header and trailer are shown for all models m1 through m8.
When the
model parameter is supplied, the specific bytes used
in the header and trailer are shown, along with the banner type,
data type and configuration number for that specific model.
list mosinfo
List the MOS version
list net
List all current TCP/IP network settings (e.g., IP address and
subnet mask).
list pping
List all the current periodic ping setting.
list prn
List the current parallel port setting (e.g., mode).
list pserver
List the current general print server settings (e.g., print server
name and Novell mode).
NOTE: Novell parameters are listed on Adapter and Wireless
Ethernet Interfaces only.
ADAPTER,
WIRELESS
ADAPTER
list rprinter
List any current RPRINTER definitions.
list snmp
List the Trap Table containing SNMP Managers.
list stored tn
List all the tn protocol settings which are stored in the flash
memory. If there is no valid settings stored in flash then the
default setting are listed. If this is done then an “*” is added to
the word “stored” in the top left corner of the displayed list table.