IBM INFOPRINT 6500 - Manual (Page 172)

Chapter 5 Unix Troubleshooting Tips
172
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway
parameters to the desired values.
12. If the Web browser access does not work, telnet into the
Ethernet Interface as root. Enter the following command:
config http on
ETHERNET,
WIRELESS
To reset all Integrated Ethernet Interface TCP/IP values to the
factory defaults when access is impossible, contact your IBM
service representative for assistance.
Front Panel Message - Dynamically Set Params
Read Only
This is not an error. It is an informational message warning that the
IP address has been dynamically set by dhcp, rarp, or bootp.
To assign a static IP address, turn off the rarp, bootp, and dhcp on
the adapter. Use the following procedure:
1. Telnet to the adapter. Login = root, password = (Enter key)
Telnet commands are:
store tcpip 1 opts -rarp -bootp -dhcp
reset
Wait two minutes for the adapter to reset.
2. Program the IP address, Subnet Mask, and Gateway (if
required) from the front panel.