IBM INFOPRINT 6500 - Manual (Page 55)

Configuration Using The Control Panel
55
CAUTION Turning off the printer before the firmware update is complete
may permanently damage the Ethernet Interface adapter.
Updating the printer firmware takes time. Please be patient
and wait for the “ETHERNET IS READY” message to display
on the LCD. Do not turn off the printer before it has completed
the firmware download procedure. The LCD will display
“ONLINE / ETHERNET IS READY” when the download is
complete. Wait for this message before turning off the printer.
6. To enter IP Address parameters, do the following:
a. Press STOP to get to the NOT READY state.
b. Press RETURN + ENTER to unlock the printer menu.
c. Press Menu to display OPERATOR MENU.
d. Press
↑ Scroll/Micro until NETWORK SETUP displays,
then press Enter.
e. Press ↑ Scroll/Micro until ADAPTER ADDRESS or
ETHERNET ADDRESS displays, then press Enter.
f. Press
↑ Scroll/Micro until IP ADDRESS displays, then
press Enter.
g. Press Enter again, then
↑ Scroll/Micro to choose an IP
address octet to change. Press Enter.
h. Press ↑ Scroll/Micro to choose the desired value for the
octet, then press Enter. The new value is shown with an
asterisk. Press Return.
i. Repeat steps d and e until you have set all IP address
octets to the desired value.
j. Press Return until ADAPTER ADDRESS or ETHERNET
ADDRESS is on the first display line.
k. Press ↑ Scroll/Micro to choose other IP parameters to
change, then follow the above steps for each of these.
l. When finished, press Return multiple times until NOT
READY displays.
m. Press Start.