IBM INFOPRINT 6500 User Manual
Page 351
Set Commands
351
set snmp trap
Enable or disable an SNMP trap manager table entry.
is the index number of the SNMP trap manager
table. “active” enables the table entry, “-active” disables the
entry.
set snmp emailaddr
The Ethernet Interface can also send SNMP alert messages to
a desired e-mail address. To specify an e-mail address to send
alert messages to, use this command to add the e-mail address
to the SNMP alert table.
is the index number of the SNMP trap manager table.
[email protected].
set snmp emailformat
Enable or disable the short e-mail message format for an
SNMP alert table entry. When enabled, the short e-mail format
can be used when messages will be viewed on devices having
a limited display size (a cellular phone or pager, for example).
is the index number of the SNMP alert table. “short”
enables the short e-mail format, “-short” disables it.
set snmp shortmsglen
Specify the length of the short e-mail message format for an
SNMP alert table entry. This command is effective only when
the short e-mail message format for an SNMP alert table entry
is enabled.
is the index number of the SNMP alert table. “length”
specifies the length of the short e-mail message, and has an
acceptable range of 15 to 80 characters.
set snmp email
Enable or disable sending e-mail alert messages for an SNMP
alert table entry.
is the index number of the SNMP alert table. “active”
enables sending e-mail alert messages, “-active” disables it.