IBM INFOPRINT 6500 - Manual (Page 348)

Chapter 16 Complete Command List
348
set model header []
Example: set model m1 header 0x20
Set a header string to be sent to the printer at the start of any
print jobs passing through this model
. The header
can consist of up to nine elements. An example
element is a hexadecimal code (e.g., 0x04) or a pre-defined
variable on the print server (e.g., $FF for a formfeed). Use
list var to see all available variables. To erase the header,
send the command with no headerstring value; for example ‘set
model m1 header’.
set model trailer []
Example: set model m7 trailer $FF
Set a trailer string to be sent to the printer at the start of any
print jobs passing through this model
. The trailerstring
can consist of up to nine elements. An example
element is a hexadecimal code (e.g., 0x04) or a pre-defined
variable on the print server (e.g., $FF for a formfeed). Use
list var to see all available variables. To erase the trailer,
send the command with no trailerstring value; for example ‘set
model m1 trailer’.
set model config [config _num]
Set a printer configuration number [config_num] to be loaded
prior to printing a job on the specified model. If the command is
sent with config_num set to 0, the factory configuration is
loaded before the job prints. If config_num is in the range 1
through 8, the corresponding configuration number is loaded
before the job prints. To return to the default state where no
configuration is loaded, send the command with no config_num
value; for example ‘set model m1 config’. When no new
configuration is loaded, the current configuration settings will
be in effect for any jobs sent to model . To see which
configuration, if any, will be loaded at the start of a job, use the
command ‘list model’ or ‘list model ’.
set model from default
Set all model settings back to factory defaults.