IBM INFOPRINT 6500 - Manual (Page 138)

Chapter 4 Windows Troubleshooting Tips
138
6. From a workstation attached to this network segment, create
an ARP entry. The Ethernet Interface IP address and hardware
or Machine Address Code (MAC) address are needed. At the
workstation enter:
arp -s <ipaddress> <MACaddress>
ping <ipaddress>
7. Try to ping this IP address to see if the Ethernet Interface can
be seen on your network. If the interface does not respond,
verify you are on the same network segment as the printer and
that the ARP entry was created.
8. Telnet into the Ethernet Interface using the same IP address
as above. Log in as root. There is no password by default.
9. At the system prompt, enter:
store tcpip from default
config http on
save
reset
NOTE: This will reset all TCP/IP settings to factory default and
reset the Ethernet Interface.
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway
parameters to the desired values.
WIRELESS,
ETHERNET
To reset all Integrated Ethernet Interface TCP/IP values to the
factory defaults when access is impossible, contact your IBM
service representative for assistance.