IBM INFOPRINT 6500 - Manual (Page 305)

Getting Started
305
Example: tn dest d1prn start
By using the manual method, time is allowed to properly
prepare the iSeries after the printer is powered up but before a
connection is established. This method should only be used
during an initial installation until the printer and the iSeries are
synchronized. The normal method is to have autoconnect
enabled.
The autoconnect feature has a cycle time of approximately one
minute. A little patience may be required when first turning on
the printer before the connection becomes visible on the
iSeries.
TN5250 Job Formatting
Forms width, forms length, CPI and LPI are controlled by the
TN5250 data stream unless the front panel TN5250 Host Override
option is enabled. The CPI is controlled through TN5250 via the
font selection in the Change Device Description (CHGDEVPRT)
command.
A completed screen looks like the example shown in Figure 41.
Change Device Desc (Printer) (CHGDEVPRT)
Type choices, then press Enter.
Device description DEVD
Online at IPL ONLINE *NO
Font: FONT
Identifier 011
Point Size *NONE
Form Feed FORMFEED *CONT
Separator drawer SEPDRAWER *FILE
TN5250 Job Formatting