IBM INFOPRINT 6500 - Manual (Page 254)

Chapter 9 Configuring On iSeries As An IPDS Printer
254
Figure 33. Example CRTPSFCFG Command (V4R2 and above)
3. The following parameters are recommended: PSF
configuration (PSFCFG)
The name used for this PSF configuration object. The name must
match the user-defined object name (USRDFNOBJ) in the printer
DEVD.
PSF configuration (PSFCFG)
The name used for this PSF configuration object. The name must
match the user-defined object name (USRDFNOBJ) in the printer
DEVD.
IPDS pass through (IPDSPASTHR)
To print SCS files, specify *YES, PSF transforms SCS into IPDS
before printing.
Release timer (RLSTMR)
Specifies the amount of time to wait before a session or dialog is
released without terminating the writer. The ACTRLSTMR
parameter specifies when this timer is to be activated. Set the
parameter to a value at least equal to the TIMEOUT value on the
printer. IBM recommends *SEC15.
Page size control (PAGSIZCTL)
Specifies if the page size (forms) is set by PSF. Usually set to
*YES.
Remote Location name or address (RMTLOCNAME)
Enter the IP address or hostname of the printer.
Cut sheet emulation mode ......... *NONE *NONE, *CHKFIRST, *CHKALL
Use DBCS simulation fonts *NO *YES, *NO
Replace ...................................... *YES *YES, *NO
Authority ..................................... *LIBCRTAUT Name, *LIBCRTAUT,
*CHANGE...