IBM INFOPRINT 6500 - Manual (Page 362)

Chapter 16 Complete Command List
362
ping [-s] hostIPaddress [datasize [packetnumber]]
Example: ping 192.75.11.30
ping another TCP/IP host specified by hostIPaddress on
the Ethernet Interface network. datasize is the datagram
packet size which defaults to 64 bytes if no size is included in
the syntax and packetnumber is the number of requests to be
sent.
NOTE: To use a host or IP name instead of the address, you must
have set the DNS server on the Ethernet Interface. Use the
command set sysinfo dns... to do this.
reboot
Perform a warm boot or hardware reset to simulate a power-on
reset. This restores current settings to those stored in flash
memory, since the flash memory settings will be read and
loaded into memory upon bootup.
reset
Perform a warm boot or hardware reset to simulate a power-on
reset. This restores current settings to those stored in flash
memory, since the flash memory settings will be read and
loaded into memory upon bootup.
save [default]
Save the current settings to flash memory so they are available
after power cycles. Sysinfo, destination, model, logpath,
variable, user, and I/O port settings will be saved. If
default
is specified as well, factory settings will be saved, overwriting
any new settings you have configured.