IBM INFOPRINT 6500 - Manual (Page 302)

Chapter 12 Setting Up A TN5250 Connection/Device Via A Telnet Session
302
NOTE: It is not necessary to set up the devd or queue name on the
iSeries manually or in advance. The configuration and
reset of the Ethernet adapter automatically sets up the
devd or queue name.
Setting Up A TN5250 Connection/Device Via A
Telnet Session
In a telnet session, the command “list tn” shows the configured
values. To set up a TN5250 connection/device via a telnet session,
use the commands “store TN...” and the following:
NOTE: The Ethernet sessions can be configured either by a web
browser or by telnet.
1. Use cmd WRKCTLD *VWS, choice 5, display, enter to list the
number of virtual devices this controller.
2. Use cmd DSPSYSVAL QAUTOVRT. Note the number of auto-
configured virtual devices permitted on the system. This
number must be greater than one.
3. Use cmd DSPYSYVAL QCHRID. This is the system language
(code page) available.
4. Use cmd WRKTCPSTS *IFC to determine the IP address of the
iSeries. This value is used in setting the Ethernet TN5250
devices.