Mocomtech CDM-QX - Manual (Page 258)

CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier® Revision 7
Appendix C MN/CDMQX.IOM
C–40
C.6.10 D&I++ (Drop & Insert) Commands and Queries (E1 CCS Only) – Modem ONLY
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Drop & Insert DNI= 65 bytes Command or Query.
DNI=dddddddddddddddddddddddddddddddtiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiTL
31 bytes of Drop information:
d = 31 bytes defining timeslot locations (or channels)
t = Drop type:
(0=reserved, 1=reserved, 2=E1-CCS, 3=reserved)
31 bytes of Insert information:
I = 31 bytes defining timeslot locations (or channels)
T = Insert type:
(0=reserved, 1=reserved, 2=E1-CCS, 3=reserved)
Timeslot definition:
0 = Unused
1-9 for timeslots 1–9, A=10, B=11, C=12, D=13…V=31.
L= reserved (set to 0)
Example: 123456789ABCDEFGHIJKLMNOPQRSTUV2123456789
ABCDEFGHIJKLMNOPQRSTUV20
Drop channels 1–31 using timeslots 1–31. Same for Insert.
Note: This command is a bit forgiving in the sense that the modem
accepts the command even though the interface type is other than
G.703. This was intentional because it’s being used with the CRS-
300 switch for 1:N redundancy.
DNI=
DNI?
DNI*
DNI#
DNI$
DNI^
DNI?
DNI?n DNI=ddddddddddddddddd
ddddddddddddddtiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiTL
(see Description of
Arguments)
Returns current D&I
configuration.
Where n=0 to 9 returns the
DNI portion of 1 of 10
stored configurations.
Drop Timeslot DTS= 3 bytes for
command, 31
bytes for query Command or Query.
(Note different format between command and query.)
Command in the form xxy, where:
xx = Channel 01 through 31
y = timeslot: 0-9, A=10, B=11, C=12, D=13,…V=31
DTS=
DTS?
DTS*
DTS#
DTS$
DTS^
DTS? DTS=yyyyyyyyyyyyyyyyyy
yyyyyyyyyyyyy
Indicating all 31 Drop
timeslots values
associated with the 31 Tx
Satellite channels.
Insert
Timeslot ITS= 3 bytes for
command, 31
bytes for query Command or Query.
(Note different format between command and query.)
Command in the form xxy, where:
xx = Channel 01 through 31
y = timeslot: 0-9, A=10, B=11, C=12, D=13,…V=31
ITS=
ITS?
ITS*
ITS#
ITS$
ITS^
ITS? ITS=yyyyyyyyyyyyyyyyyyy
yyyyyyyyyyyy
Indicating all 31 Insert
timeslots values
associated with the 31 Rx
Satellite channels.