Mocomtech CDM-QX - Manual (Page 113)

CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier® Revision 7
Front Panel Operation MN/CDMQX.IOM
5–47
IMPORTANT
5.5.4.2 MONITOR: Stats
Æ Clear-All
Clear All Stored Stats?
No Yes (◄ ►,ENT)
When selected, and in Local mode, the user is prompted to answer No to retain the stored link
statistics, or Yes to clear the buffer of all stored link statistics. Select the choice using the ◄ ►
arrow keys, then press
ENTER
.
Note: When the unit is in Remote mode, and the Clear-All menu is selected, the following message
is displayed:
THIS UNIT IS CURRENTLY
IN REMOTE MODE!!
When the link statistics log is cleared, the user is returned to the previous menu.
5.5.4.3 MONITOR: Stats Æ Config
Stats Logging Interval:
30 minutes (◄ ►,ENT)
Select a logging interval for the link statistics (i.e., the period of time, in minutes, for which
statistics will be measured) using the
ST arrow keys, then press
ENTER
. The available
selections are Disabled, 10, 20, 30, 40, 50, 60, 70, 80, or 90.
5.5.5 MONITOR: AUPC
• This read-only screen is operable only for a modulator/demodulator pair
grouped as a ‘modem’.
• Framing mode must be active in order for correct viewing of this screen.
If MONITOR: AUPC is selected, and the modem is not in Framed mode, the
following message displays:
Framing is required for
AUPC Monitor (ENT or CLR)
Press ENTER or CLEAR to return to the previous menu, then, via the CONFIG:
Frame
menus, configure the modem as needed for Framing mode.
Once configured for Framed mode, when MONITOR: AUPC is selected, the
proper read-only screen should display:
AUPC:Remote EbNo = 14.0dB
TX Power Increase = 2.2dB
Per this example:
• The top line displays the value of Eb/No of the demodulator at the distant end of the
satellite link. The Eb/No displays Unlock if the remote demod is unlocked.
• The bottom line shows how much the AUPC system has increased the output power. If
AUPC is not enabled, the value of Tx Power Increase will show as 0.0 dB.