Inter-Tel Axxess - Manual (Page 25)

Page 9
Administrator Procedures
AXXESS ® ADMINISTRATOR’S GUIDE – January 2004
Placing the System in Night Mode
PLACING THE SYSTEM IN NIGHT MODE
An administrator station can place the local node in day or night mode. The day/night mode
determines which lists the system will use for trunk access, toll restriction, etc.
Night mode also affects the night transfer relays on the Options Card (OPC). The relays are
activated when the system is placed in night mode. See SPECIFICATIONS in the Installation
Manual for details.
T O TURN NIGHT MODE ON OR OFF :
While on hook, enter the Night Ring On/Off feature code (9860). You hear a single
confirmation tone. The display shows NIGHT MODE IS ON (or OFF). Then, if night
mode was turned on, the display shows THE SYSTEM IS IN NIGHT MODE until day
mode is turned on.
PLACING NODES IN DAY OR NIGHT MODE
An administrator station can place one or more nodes in day or night mode. The day/night
mode determines which lists the system will use for trunk access, toll restriction, etc.
The network determines the day/night mode status of a call based on the day/night mode status
of the node where the trunk resides.
T O TURN NIGHT MODE ON :
1. While on hook, enter the Enable Network Night feature code (9861).
2. You are prompted to enter a node number. Enter the desired node number.
3. You hear a single confirmation tone. The display shows NIGHT MODE IS ON. Then
the display shows NODE X IS IN NIGHT MODE until day mode is turned on.
T O TURN DAY MODE ON :
1. While on hook, enter the Enable Network Day feature code (9862).
2. You are prompted to enter a node number. Enter the desired node number.
3. You hear a single confirmation tone. The display shows DAY MODE IS ON.