Inter-Tel Axxess - Manual (Page 137)

Page 121
System Features
AXXESS ® ADMINISTRATOR’S GUIDE – January 2004
Station Feature Codes
Program Station Password 392 The Station password is used for the Remote Program-
ming feature. The password can be changed by entering
the Program Station Password feature code at the station
or when using the Remote Programming feature.
Queue Request 6 Requests (or cancels) an automatic callback when a busy
trunk or station becomes available. (Analog phones have
a default QUEUE button.)
Record-A-Call 385 If the system is programmed with a Record-A-Call applica-
tion, the stations can be programmed to use the Record-
A-Call feature. It allows users to enter a feature code
whenever they want to record an ongoing call in their des-
ignated Record-A-Call mailbox. Users can retrieve the
recorded messages later, just as they would any other
mailbox messages.
Redial 380 Redials the last outside telephone number dialed or saved
at the station (up to 48 digits). Also used to save numbers
at phones programmed for last number saved. (Inter-Tel
phones use the REDIAL button.)
Redirect Call 331 This feature allows the phone user to route ringing out-
side, intercom, and camped on calls to another station,
hunt group, or outside number. Routing of the redirected
call is still subject to trunk and toll restrictions. This feature
provides these options in addition to the currently avail-
able options which allow the station user to redirect calls
to voice mail or Do-Not-Disturb. The Redirect Ringing Call
feature does not require any premium features.
Reminder Message
Reminder Message Cancel
305
306
(Inter-Tel Phones Only) The phone user can set reminder
messages that signal the station at specific times. Or, the
user can cancel all reminder messages for the station.
Remote Programming 359 Allows a user to place a phone in Do-Not-Disturb mode or
forward the station’s calls, either from another station or
through DISA.
Reverse Transfer (Call Pick-Up) 4 Picks up a call ringing or holding at a station or hunt group
Review Keys 396 (Inter-Tel Phones Only) User-programmable feature but-
tons and station speed-dial buttons can be viewed using
this feature code.
Ring Intercom Always On/Off 377 Enables/disables the feature that allows the station to
always place private (non-handsfree) intercom calls.
Ring Tone Selection 398 (Inter-Tel Phones Only) Selects the type of ringing alert
tone that will be heard from the phone.
Routing Off 304 Disables System OAI Offering Control for third-party apli-
cations. (This feature requires you to enter a password.)
Once you disable routing, you cannot enable it again (i.e.,
only the third-party application can enable routing).
Station Monitor 321 (Hunt Group Supervisors Only) Allows a designated hunt
group supervisor to monitor a call of anyone in the associ-
ated hunt group.
FEATURE NAME CODE DEFINITION (Continued)