Inter-Tel Axxess - Manual (Page 109)

Page 93
System Hardware
AXXESS ® ADMINISTRATOR’S GUIDE – January 2004
Digital Phone LED Rates
Termination of a data call may be accomplished in one of three ways:
•
Your data device can hang up. This causes the trunk or intercom channel to be released,
terminating the call to the other data device.
•
The other data device may hang up. When the call is disconnected, the button is
unlit. Depending on the type of device used, the data device may detect the loss of car-
rier and automatically terminate the entire connection. If the data device does not have
this capability, you must manually cause the data device to hang up.
•
The data call can be transferred to an associated phone’s primary voice path (releasing
the data device) and then disconnected by the phone. Note however that the
button will flutter rapidly if the data device does not hang up before the Inactivity timer
expires.
T O TERMINATE DATA DEVICE CONNECTION :
To have the data device disconnect the call: Use the appropriate commands for the
data device to instruct it to hang up. When the call is disconnected, the
button
is unlit.
To transfer the data call back to an associated Inter-Tel phone before disconnect-
ing the call: While on or off hook:
a. Press the fluttering
button. The button goes off. If desired, speak to
the party at the site of the remote data device. This can only be done if the modem
at the site of the remote data device can be turned off without disconnecting the
trunk.
b. To disconnect: If off hook, hang up. If on hook, press the Speaker button. The
button will flutter rapidly until the data device hangs up.
8-Line IMX AIM Analog Phones on Dual Circuits
If desired, 8-line IMX AIM Analog Phones can be installed two to a circuit using the Analog
Keyset Card (AKSC). To do this, single Analog Keyset Card (AKSC) circuits are designated
as “dual” circuits in System Configuration programming. (Other Inter-Tel phone models can-
not be installed two to a circuit.) The designated dual circuit becomes two circuits that can be
programmed individually.
DATA
DATA
DATA
DATA DATA
DATA