Honeywell MK VI - Manual (Page 214)

Honeywell
MK VI MK VIII EGPWS Installation Design Guide
Proprietary notice on title page applies
CAGE CODE: 97896 SCALE: NONE SIZE: A DWG NO: 060-4314-150 REV: SHEET 214
Table 5.3.6.1-15 Honeywell P880/660/440, (Integrated) WXPD with SCI range and A/C symbol
Display Configuration Group 13
Function Value Reference section
Display Type Honeywell P880/660/440 radar displays (Integrated) with A/C symbol
Sweep Type Honeywell
Category 7, Options Select Group #1
TA&D Alternate Pop Up: False TA&D Alternate Pop Up: True
Auto Pop Up
Pop Up On Caution or Warning Never Pop Up
5.3.7
Category 7, Options Select Group #1
Peaks Enable: False Peaks Enable: True
Peaks Mode
Peaks Off Peaks On
5.3.7
Manual select Anytime
Manual deselect Anytime
Auto Range No
Moving Marker Yes (across bottom of display)
Overlay Page Yes, for Peaks Elevations located lower left of the display
Display bus type Honeywell picture bus
DISPLAY BUS #1
453TX_1 CONNECT TO:
A = J1-58
B = J1-59 Terrain Display data to switching relay/Symbol Generator 4.2.13.2
7.2
DISPLAY BUS #2
453TX_2 CONNECT TO:
Not supported for this display type
Display Input Control Group 3
CHANNEL
429_422RX_1 CONNECT TO: SCI Bus 1
Format: RS-422 (12K baud) Fault Designation: DISPLAY BUS 1
Bus Type: Basic
A = J2-36
B = J2-37 Data
Range (Mode/Range Word) Reference
6.5.1.1 Label
80 Sig. Bits
4 Discrete Range
2000NM Signal Type
Basic Resolution
N/A Rate (ms)
100
CHANNEL
429RX_3 CONNECT TO: Fault Designation:
Bus Type:
No Connection
CONN PIN # REFERENCE NAME PIN FUNCTION Polarity/Configuration
J1-32 GND_DISC_12 Reference
4.2.7
6.6.18 Display Select Discrete #1 Type 1 (Momentary)
Gnd = Display Select Toggle
Gnd = Normal
Output 429 Bus Group 0
Channel Pins Comments
429TX_1 (Low Speed) A = J2-43 B = J2-42 Transmits (Section 7) Label sets: 7.1.1.x, 7.1.2.x, 7.1.3.x, and 7.1.4.x
Integration Notes:
1. Radar Indicator part number must end in -X1X.
2. This display type overlays an inverted T aircraft symbol.