HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 76)

76 Fixed Cycles: Drilling
3.4 REAMING (Cy
c
le
20
1, DIN/ISO:
G20
1
)
Cycle parameters
 Set-up clearance Q200 (incremental): Distance
between tool tip and workpiece surface. Input range
0 to 99999.9999; alternatively PREDEF
 Depth Q201 (incremental): Distance between
workpiece surface and bottom of hole. Input range
-99999.9999 to 99999.9999
 Feed rate for plunging Q206: Traversing speed of
the tool in mm/min during reaming. Input range 0 to
99999.999; alternatively FAUTO, FU
 Dwell time at depth Q211: Time in seconds that the
tool remains at the hole bottom. Input range 0 to
3600.0000; alternatively PREDEF
 Feed rate for retraction Q208: Traversing speed of
the tool in mm/min when retracting from the hole. If
you enter Q208 = 0, the feed rate for reaming applies.
Input range 0 to 99999.999
 Coordinate of workpiece surface Q203 (absolute):
Coordinate of the workpiece surface. Input range 0 to
99999.9999
 2nd set-up clearance Q204 (incremental): Coordinate
in the spindle axis at which no collision between tool
and workpiece (fixtures) can occur. Input range 0 to
99999.9999; alternatively PREDEF
Beispiel: NC blocks
11 CYCL DEF 201 REAMING
Q200=2 ;SET-UP CLEARANCE
Q201=-15 ;DEPTH
Q206=100 ;FEED RATE FOR PLNGNG
Q211=0.5 ;DWELL TIME AT DEPTH
Q208=250 ;RETRACTION FEED RATE
Q203=+20 ;SURFACE COORDINATE
Q204=100 ;2ND SET-UP CLEARANCE
12 L X+30 Y+20 FMAX M3
13 CYCL CALL
14 L X+80 Y+50 FMAX M9
15 L Z+100 FMAX M2
X
Z
Q200
Q201
Q206
Q211
Q203
Q204
30
X
Y
20
80
50