HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 141)

HEIDENHAIN iTNC 530 141
5.2 RECT
ANGULAR POCKET (Cy
c
le
251, DIN/ISO:
G251)
Cycle parameters
 Machining operation (0/1/2) Q215: Define the
machining operation:
0: Roughing and finishing
1: Only roughing
2: Only finishing
Side finishing and floor finishing are only executed if
the respective finishing allowance (Q368, Q369) has
been defined
 1st side length Q218 (incremental): Pocket length,
parallel to the reference axis of the working plane.
Input range 0 to 99999.9999
 2nd side length Q219 (incremental): Pocket length,
parallel to the minor axis of the working plane. Input
range 0 to 99999.9999
 Corner radius Q220: Radius of the pocket corner. If
you have entered 0 or a value smaller than the tool
radius, the TNC defines the corner radius to be equal
to the tool radius. In these cases, the TNC will not
display an error message. Input range 0 to
99999.9999
 Finishing allowance for side Q368 (incremental):
Finishing allowance in the working plane. Input range
0 to 99999.9999
 Angle of rotation Q224 (absolute): Angle by which
the entire pocket is rotated. The center of rotation is
the position at which the tool is located when the
cycle is called. Input range -360.0000 to 360.0000
 Pocket position Q367: Position of the pocket in
reference to the position of the tool when the cycle is
called:
0: Tool position = Center of pocket
1: Tool position = Lower left corner
2: Tool position = Lower right corner
3: Tool position = Upper right corner
4: Tool position = Upper left corner
 Feed rate for milling Q207: Traversing speed of the
tool in mm/min while milling. Input range 0 to
99999.999; alternatively FAUTO, FU, FZ
 Climb or up-cut Q351: Type of milling operation with
M3:
+1 = climb milling
–1 = up-cut milling
+0 = climb milling; if a mirror function is active, the
climb milling method remains effective
Alternatively PREDEF
X
Y
Q21
9
Q218
Q207
Q220
X
Y
X
Y
X
Y
X
Y
Q367=0
Q367=1 Q367=2
Q367=3 Q367=4
X
Y
k
Q351= +1
Q351= –1