Cycle parameters – HEIDENHAIN iTNC 530 (60642x-04) Cycle programming User Manual
Page 264
264
Fixed Cycles: Multipass Milling
1
0
.3 MUL
T
IP
A
SS MILLING (Cy
c
le
230, DIN/ISO:
G230)
Cycle parameters
Starting point in 1st axis
Q225 (absolute):
Minimum-point coordinate of the surface to be
multipass-milled in the reference axis of the working
plane. Input range -99999.9999 to 99999.9999
Starting point in 2nd axis
Q226 (absolute):
Minimum-point coordinate of the surface to be
multipass-milled in the minor axis of the working
plane. Input range -99999.9999 to 99999.9999
Starting point in 3rd axis
Q227 (absolute): Height
in the spindle axis at which multipass-milling is carried
out. Input range -99999.9999 to 99999.9999
First side length
Q218 (incremental): Length of the
surface to be multipass-milled in the reference axis of
the working plane, referenced to the starting point in
the 1st axis. Input range 0 to 99999.9999
Second side length
Q219 (incremental): Length of
the surface to be multipass-milled in the minor axis of
the working plane, referenced to the starting point in
the 2nd axis. Input range 0 to 99999.9999
Number of cuts
Q240: Number of passes to be made
over the width. Input range 0 to 99999
Feed rate for plunging
Q206: Traversing speed of
the tool in mm/min when moving from set-up
clearance to the milling depth. Input range 0 to
99999.9999; alternatively FAUTO, FU, FZ
Feed rate for milling
Q207: Traversing speed of the
tool in mm/min during milling. Input range 0 to
99999.9999; alternatively FAUTO, FU, FZ
Stepover feed rate
Q209: Traversing speed of the
tool in mm/min when moving to the next pass. If you
are moving the tool transversely in the material, enter
Q209 to be smaller than Q207. If you are moving it
transversely in the open, Q209 may be greater than
Q207. Input range 0 to 99999.9999; alternatively
FAUTO
, FU, FZ
Set-up clearance
Q200 (incremental): Distance
between tool tip and milling depth for positioning at
the start and end of the cycle. Input range 0 to
99999.9999; alternatively PREDEF
Beispiel: NC blocks
71 CYCL DEF 230 MULTIPASS MILLING
Q225=+10
;STARTING POINT 1ST AXIS
Q226=+12
;STARTING POINT 2ND AXIS
Q227=+2.5 ;STARTING POINT 3RD AXIS
Q218=150
;1ST SIDE LENGTH
Q219=75
;2ND SIDE LENGTH
Q240=25
;NUMBER OF CUTS
Q206=150
;FEED RATE FOR PLNGNG
Q207=500
;FEED RATE FOR MILLING
Q209=200
;STEPOVER FEED RATE
Q200=2
;SET-UP CLEARANCE
X
Y
Q226
Q225
Q219
Q218
Q207
Q209
N = Q240
X
Z
Q200
Q227
Q206