HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 499)

HEIDENHAIN iTNC 530 499
1
8
.5 PRESET COMPENSA
TION (Cy
c
le 452, DIN/ISO:
G452, Option)
If it is possible to leave the calibration sphere clamped to the machine
table during machining, you can compensate for machine drift, for
example. This procedure is also possible on a machine without rotary
axes.
1 Clamp the calibration sphere and check for potential collisions.
2 Set the preset in the calibration sphere.
3 Set the preset on the workpiece, and start machining the
workpiece.