HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 391)

HEIDENHAIN iTNC 530 391
15.9 D
A
TUM FR
OM INSIDE OF CORNER (Cy
c
le 415, DIN/ISO:
G415)
 Traversing to clearance height Q301: Definition of
how the touch probe is to move between the
measuring points:
0: Move at measuring height between measuring
points
1: Move at clearance height between measuring
points
Alternative: PREDEF
 Execute basic rotation Q304: Definition of whether
the TNC should compensate workpiece misalignment
with a basic rotation:
0: No basic rotation
1: Basic rotation
 Number in table Q305: Enter the number in the
datum/preset table in which the TNC is to save the
coordinates of the corner. If you enter Q305=0 and
Q303=1, the TNC automatically sets the display so
that the new datum is on the corner. If you enter
Q305=0 and Q303=0, the TNC writes the corner in
line 0 of the datum table. Input range 0 to 99999
 New datum for reference axis Q331 (absolute):
Coordinate in the reference axis at which the TNC
should set the corner. Default setting = 0. Input range
-99999.9999 to 99999.9999
 New datum for minor axis Q332 (absolute):
Coordinate in the minor axis at which the TNC should
set the corner. Default setting = 0. Input range
-99999.9999 to 99999.9999
 Measured-value transfer (0, 1) Q303: Specify
whether the determined datum is to be saved in the
datum table or in the preset table:
-1: Do not use. Is entered by the TNC when old
programs are read in (siehe „Saving the calculated
datum” auf Seite 360).
0: Write determined datum in the active datum table.
The reference system is the active workpiece
coordinate system.
1: Write determined datum in the preset table. The
reference system is the machine coordinate system
(REF system).