HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 193)

HEIDENHAIN iTNC 530 193
7.
5 PIL
O
T DRILLING (Cy
c
le 21, DIN/ISO:
G121)
Cycle parameters
 Plunging depth Q10 (incremental): Dimension by
which the tool drills in each infeed (negative sign for
negative working direction). Input range -99999.9999
to 99999.9999
 Feed rate for plunging Q11: Traversing speed of the
tool in mm/min during drilling. Input range 0 to
99999.9999; alternatively FAUTO, FU, FZ
 Rough-out tool number/name Q13 or QS13: Number
or name of rough-out tool. Input range 0 to 32767.9 if
a number is entered; maximum 32 characters if a
name is entered.
Beispiel: NC blocks
58 CYCL DEF 21 PILOT DRILLING
Q10=+5 ;PLUNGING DEPTH
Q11=100 ;FEED RATE FOR PLNGNG
Q13=1 ;ROUGH-OUT TOOL
X
Y