HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 104)

104 Fixed Cycles: Tapping / Thread Milling
4.1 F
undamentals
4.1 Fundamentals
Overview
The TNC offers 8 cycles for all types of threading operations:
Cycle Soft key Page
206 TAPPING NEW
With a floating tap holder, with automatic
pre-positioning, 2nd set-up clearance Seite 105
207 RIGID TAPPING NEW
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance Seite 107
209 TAPPING W/ CHIP BREAKING
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance, chip breaking Seite 110
262 THREAD MILLING
Cycle for milling a thread in pre-drilled
material Seite 115
263 THREAD MILLING/CNTSNKG
Cycle for milling a thread in pre-drilled
material and machining a countersunk
chamfer Seite 118
264 THREAD DRILLING/MILLING
Cycle for drilling into solid material with
subsequent milling of the thread with a
tool Seite 122
265 HEL.THREAD DRILLING/MILLING
Cycle for milling the thread into solid
material Seite 126
267 OUTSIDE THREAD MILLING
Cycle for milling an external thread and
machining a countersunk chamfer Seite 126