HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 464)

464 Touch Probe Cycles: Special Functions
1
7.3 CALIBRA
TE TS LENGTH (Cy
c
le
9)
17.3 CALIBRATE TS LENGTH
(Cycle 9)
Cycle run
Touch Probe Cycle 9 automatically calibrates the length of a touch
trigger probe at a point that you determine.
1 Pre-position the touch probe so that the touch probe axis
coordinate defined in the cycle can be accessed without collision.
2 The TNC moves the touch probe in the direction of the negative
tool axis until a trigger signal is released.
3 Finally, the TNC moves the touch probe back to the starting point
of the probing process and writes the effective touch probe length
to the calibration data.
Cycle parameters
 Coordinate of datum (absolute): Exact coordinate of
the point that is to be probed. Input range
-99999.9999 to 99999.9999
 Reference system? (0=ACT/1=REF) : Specify the
coordinate system on which the entered datum is to
be based:
0: Entered datum is based on the active workpiece
coordinate system (ACT system)
1: Entered datum is based on the active machine
coordinate system (REF system)
Beispiel: NC blocks
5 L X-235 Y+356 R0 FMAX
6 TCH PROBE 9.0 CALIBRATE TS LENGTH
7 TCH PROBE 9.1 DATUM +50 REFERENCE
SYSTEM 0