HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 146)

146 Fixed Cycles: Pocket Milling / Stud Milling / Slot Milling
5.3 CIR
C
ULAR POCKET (Cy
c
le 252, DIN/ISO:
G252)
Cycle parameters
 Machining operation (0/1/2) Q215: Define the
machining operation:
0: Roughing and finishing
1: Only roughing
2: Only finishing
Side finishing and floor finishing are only executed if
the respective finishing allowance (Q368, Q369) has
been defined
 Circle diameter Q223: Diameter of the finished
pocket. Input range 0 to 99999.9999
 Finishing allowance for side Q368 (incremental):
Finishing allowance in the working plane. Input range
0 to 99999.9999
 Feed rate for milling Q207: Traversing speed of the
tool in mm/min while milling. Input range 0 to
99999.999; alternatively FAUTO, FU, FZ
 Climb or up-cut Q351: Type of milling operation with
M3:
+1 = climb milling
–1 = up-cut milling
+0 = climb milling; if a mirror function is active, the
climb milling method remains effective
Alternatively PREDEF
 Depth Q201 (incremental): Distance between
workpiece surface and bottom of pocket. Input range
-99999.9999 to 99999.9999
 Plunging depth Q202 (incremental): Infeed per cut.
Enter a value greater than 0. Input range 0 to
99999.9999
 Finishing allowance for floor Q369 (incremental):
Finishing allowance in the tool axis. Input range 0 to
99999.9999
 Feed rate for plunging Q206: Traversing speed of
the tool in mm/min while moving to depth. Input
range 0 to 99999.999; alternatively FAUTO, FU, FZ
 Infeed for finishing Q338 (incremental): Infeed per
cut. Q338=0: Finishing in one infeed. Input range 0 to
99999.9999
X
Y
Q207
Q223
X
Z
Q201
Q206
Q202
Q338