HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 442)

442 Touch Probe Cycles: Automatic Workpiece Inspection
16.9 MEA
S
URE INSIDE WIDTH (Cy
c
le 425, DIN/ISO:
G425)
 Measuring log Q281: Definition of whether the TNC is
to create a measuring log:
0: No measuring log
1: Create measuring log: By default, the TNC saves
the log file TCHPR425.TXT in the directory in which
your measuring program is stored.
2: Interrupt program run and display the measuring
log on the screen. Resume program run with NC
Start.
 PGM stop if tolerance error Q309: Definition of
whether in the event of a violation of tolerance limits
the TNC is to interrupt program run and output an
error message:
0: Do not interrupt program run, no error message
1: Interrupt program run, output an error message
 Tool for monitoring Q330: Definition of whether the
TNC is to monitor the tool (siehe „Tool monitoring”
auf Seite 416). Input range: 0 to 32767.9, alternatively
tool name with max. 16 characters
0: Monitoring not active
>0: Tool number in the tool table TOOL.T
 Set-up clearance Q320 (incremental): Additional
distance between measuring point and ball tip. Q320
is added to MP6140. Input range 0 to 99999.9999;
alternatively PREDEF
 Traversing to clearance height Q301: Definition of
how the touch probe is to move between the
measuring points:
0: Move at measuring height between measuring
points
1: Move at clearance height between measuring
points
Alternative: PREDEF
Beispiel: NC blocks
5 TCH PROBE 425 MEASURE INSIDE WIDTH
Q328=+75 ;STARTING POINT 1ST AXIS
Q329=-12.5 ;STARTING POINT 2ND AXIS
Q310=+0 ;OFFS. 2ND MEASUREMENT
Q272=1 ;MEASURING AXIS
Q261=-5 ;MEASURING HEIGHT
Q260=+10 ;CLEARANCE HEIGHT
Q311=25 ;NOMINAL LENGTH
Q288=25.05 ;MAX. LIMIT
Q289=25 ;MIN. LIMIT
Q281=1 ;MEASURING LOG
Q309=0 ;PGM STOP IF ERROR
Q330=0 ;TOOL
Q320=0 ;SET-UP CLEARANCE
Q301=0 ;MOVE TO CLEARANCE