2 available cycle groups, Overview of fixed cycles – HEIDENHAIN iTNC 530 (60642x-04) Cycle programming User Manual
Page 43
HEIDENHAIN iTNC 530
43
1
.2 A
v
ailable cy
cle gr
oups
1.2 Available cycle groups
Overview of fixed cycles
The soft key row shows the available groups of cycles
If required, switch to machine-specific fixed cycles.
These fixed cycles can be integrated by your machine
tool builder.
Cycle group
Soft key
Page
Cycles for pecking, reaming, boring, and counterboring
Seite 70
Cycles for tapping, thread cutting and thread milling
Seite 104
Cycles for milling pockets, studs and slots
Cycles for producing hole patterns, such as circular or linear point patterns
SL (Subcontour List) cycles which allow the contour-parallel machining of relatively complex
contours consisting of several overlapping subcontours, cylinder surface interpolation
Cycles for multipass milling of flat or twisted surfaces
Seite 260
Coordinate transformation cycles which enable datum shift, rotation, mirror image, enlarging and
reducing for various contours
Special cycles such as dwell time, program call, oriented spindle stop, tolerance, engraving and
interpolation turning (option)