HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 503)

HEIDENHAIN iTNC 530 503
1
8
.5 PRESET COMPENSA
TION (Cy
c
le 452, DIN/ISO:
G452, Option)
 End angle B axis Q416 (absolute): Ending angle in the
B axis at which the last measurement is to be made.
Input range -359.999 to 359.999
 Angle of incid. in B axis Q417: Angle of incidence
in the B axis at which the other rotary axes are to be
measured. Input range -359.999 to 359.999
 Number meas. points B axis Q418: Number of probe
measurements with which the TNC is to measure the
B axis. If the input value = 0, the TNC does not
measure the respective axis. Input range 0 to 12
 Start angle C axis Q419 (absolute): Starting angle in
the C axis at which the first measurement is to be
made. Input range -359.999 to 359.999
 End angle C axis Q420 (absolute): Ending angle in the
C axis at which the last measurement is to be made.
Input range -359.999 to 359.999
 Angle of incid. in C axis Q421: Angle of incidence
in the C axis at which the other rotary axes are to be
measured. Input range -359.999 to 359.999
 Number meas. points C axis Q422: Number of probe
measurements with which the TNC is to measure the
C axis. If the input value = 0, the TNC does not
measure the respective axis. Input range 0 to 12
 No. of measuring points Q423: Specify the number
of probing points to be used by the TNC for
measuring the calibration sphere in the plane. Input
range: 3 to 8 measurements
 Backlash, angle range Q432: Here you define the
angle value to be used as traverse for the
measurement of the rotary axis backlash. The
traversing angle must be significantly larger than the
actual backlash of the rotary axes. If input value = 0,
the TNC does not measure the backlash. Input range
-3.0000 to +3.0000