HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 374)

374 Touch Probe Cycles: Automatic Datum Setting
15.5 D
A
TUM FR
OM OUTSIDE OF RECT
ANGLE (Cy
c
le 41
1, DIN/ISO:
G41
1
)
 Traversing to clearance height Q301: Definition of
how the touch probe is to move between the
measuring points:
0: Move at measuring height between measuring
points
1: Move at clearance height between measuring
points
Alternative: PREDEF
 Number in table Q305: Enter the number in the
datum/preset table in which the TNC is to save the
coordinates of the stud center. If you enter Q305=0
and Q303=1, the TNC automatically sets the display
so that the new datum is on the stud center. If you
enter Q305=0 and Q303=0, the TNC writes the stud
center in line 0 of the datum table. Input range 0 to
99999
 New datum for reference axis Q331 (absolute):
Coordinate in the reference axis at which the TNC
should set the stud center. Default setting = 0. Input
range -99999.9999 to 99999.9999
 New datum for minor axis Q332 (absolute):
Coordinate in the minor axis at which the TNC should
set the stud center. Default setting = 0. Input range
-99999.9999 to 99999.9999
 Measured-value transfer (0, 1) Q303: Specify
whether the determined datum is to be saved in the
datum table or in the preset table:
-1: Do not use. Is entered by the TNC when old
programs are read in (siehe „Saving the calculated
datum” auf Seite 360).
0: Write determined datum in the active datum table.
The reference system is the active workpiece
coordinate system.
1: Write determined datum in the preset table. The
reference system is the machine coordinate system
(REF system).